CatNet Systems CH-1 Help
|
General Introduction Toolbar Device Tree Tutorial User Groups Users Templates Control Points Graphics Viewing Editing Components Schedules Viewing/Editing Trends Viewing/Editing Alarms Viewing Editing Runtimes Viewing Editing Calculations Viewing/Editing |
Advanced Colors
Advanced colors allow the color and transparency of a component to change based on the value of the attached point. The component may also be set to flash to help draw attention to it. Use Advanced Colors
This option must be selected to enable advanced colors.
Conditions
The list of conditions determines what the current settings for the component will be. Each condition will be tested, from the top of the list to the bottom of the list. The last condition that is true determines the settings. The default settings are used if no other conditions are true.
Each condition contains the following settings: Use Custom Settings
This option must be selected, otherwise the condition is ignored.
Color
The color to use if this condition is true.
Alpha
This is the "Alpha" or transparency to use if the condition is true. Zero is fully transparent, 1 is fully opaque.
Flash
If selected, the component will flash if this condition is true.
Value
The value to test for this condition. The point value must be greater than (not less than or equal to) this value for the condition to be considered true.
Example - To change the color of a label showing the state of an air filter: Default - green (normal) Point value is greater than 0 - red and flashing (A digital value equates to 0 when OFF, 1 when ON.) Example - To change the color of text displaying a temperature to blue (too cold), green (in range) or red (too hot): Default - blue and flashing Point value is greater than 65 - green Point value is greater than 75 - red and flashing ![]() |
Copyright 2008, CatNet Systems |